You perform most of the daily operations required by the NS
network through the use of the provided NS 3000/iX network
commands. Complete information on the syntax and function of all
the commands is contained in Chapter 7 “Commands ” of this manual.
The NETCONTROL START
command allows you to initiate the network transport as well as
the individual networks on an active transport. The NETCONTROL STOP
command allows you to stop an individual NI or all active entities
of the network transport.
To start and stop the Network Services after the network is
started, you use the NSCONTROL START
and NSCONTROL STOP commands.
The NSCONTROL ABORT command
is useful when you need to terminate services immediately.
See Chapter 2 “Operating Your Network ” for
step-by-step instructions for using these commands.