 |
» |
|
|
|
The PLISTF
UDC executes the LISTFILE
command to list descriptions of one or more disk files. System-defined UDCs are not automatically available. Your
System Manager must use the SETCATALOG
command to make these UDCs available for your use. For example: SETCATALOG HPPXUDC.PUB.SYS;SYSTEM;APPEND |
Syntax | |
PLISTF [fileset] [,format_opt] [;outfile] Parameters | |
The following parameters are supported with the PLISTF
UDC. Refer to the LISTFILE
command for a complete explanation of the parameters used with the
PLISTF UDC. - fileset
Specifies a set of files to be listed, including
MPE and HFS files. If fileset is not
specified, the default is @. - format_opt
An output format option. If this parameter is omitted,
the default is FORMAT=0,
which shows only the file names. The format option must be specified
as a numeric value. Format names (for example, QUALIFY)
are not supported by this UDC. Refer to the LISTFILE
command for a complete description of each available format option. - outfile
The name of the output file. If this parameter is
omitted, the output is displayed to $STDLIST.
The outfile supports both MPE and HFS
syntax. The outfile cannot be $NEWPASS.
Operation Notes | |
The PLISTF
UDC lists descriptions of one or more disk files at the level of
detail you select. The UDC executes the following form of the LISTFILE
command: LISTFILE fileset ,format_opt [>outfile] Use | |
This UDC may be issued from a session, a job, a program, or
in break mode. Pressing Break
aborts execution. If a permanent file exists with the same name as specified
as outfile, then CIOR defaults are used
rather than the PLISTF
CCTL default. Examples | |
Refer to the LISTFILE
command earlier in this chapter for examples. Related Information | |
- Commands
LISTF, LISTFILE,
LISTDIR (UDC),
FINDFILE (UDC),
FINDDIR (UDC) - Manuals
None
|
