 |
» |
|
|
|
Compiles an HP Business BASIC/V program in compatibility mode.
HP Business BASIC/V is not part of the HP 3000 Series 900 Computer
System Fundamental Operating Software and must be purchased separately. Syntax | |
BBASICOMP infile [ ,[ uslfile] [ ,listfile] ] |
Parameters | |
- infile
Actual file designator of the BSAVE
file containing the HP Business BASIC/V program to be compiled.
Formal file designator is BBCIN. - uslfile
Actual file designator of the user subprogram library
(USL) file on which the object program is written, which can be
any binary output file with file code of USL
or 1024. Its
formal file designator is BBCUSL.
If the uslfile parameter is omitted, the object
code is saved to the temporary file $OLDPASS.
If entered, this parameter specifies that the file was created in
one of four ways: By using the SAVE
command to save the default USL file $OLDPASS
created by a previous compilation. By building the USL with the MPE segmenter command
BUILDUSL. Refer
to the MPE Segmenter Reference Manual (30000-90011). By creating a new USL file with the BUILD
command and specifying a file code of USL
or 1024. By specifying a nonexistent uslfile
parameter, thereby creating a permanent file of the correct size
and type.
- listfile
Actual file designator of the file on which the
program listing is written. This can be any ASCII output file. Formal
designator is BBCLIST.
Default is $STDLIST.
| | | |  | NOTE: The formal file designators used in this command (BBCIN,
BBCUSL, and BBCLIST)
cannot be backreferenced as actual file designators in the command
parameter list. For further information, refer to the "Implicit
FILE Commands for Subsystems" discussion of the FILE
command. | | | | |
Operation Notes | |
The BBASICOMP
command compiles a source program stored in a BASIC SAVE
file generated by the HP Business BASIC/V interpreter. The compiled
program executes significantly faster than the corresponding interpreted
version. A BSAVE
program file can be created from within the HP Business BASIC/V
interpreter after it is written, by using the HP Business BASIC/V
interpreter >SAVE filename
command. The program may be compiled with the BBASICOMP
command, then prepared with the PREP
command, and executed with the RUN
command . Use | |
This command may be issued from a session, job, or program.
It may not be used in BREAK. Pressing Break
suspends the execution of this command. Entering the RESUME
command continues the execution. Examples | |
To compile the HP Business BASIC/V program MYPROG
into the USL named OBJECT,
enter: If you do not choose to build a USL file, the BBASICOMP
command compiles your program, storing the object code in the default
USL file $OLDPASS. If you now want to run your program, use the PREPRUN
command: Related Information | |
- Commands
BBASIC,
BBASICGO, BBASICPREP - Manuals
HP Business BASIC/XL Reference Manual MPE Segmenter Reference Manual
|
