 |
» |
|
|
|
Window mode. Changes the mode for the Q or S window. Syntax | |
QM [addressmode] [signed]
SM [addressmode] [signed]
|
Parameters | |
- addressmode
This parameter specifies the mode in which addresses are to be displayed.
If no value is specified, DB is the default.
The following values are allowed: - DB
Display address as DB-relative values (initial mode).
- DL
Display address as DL-relative values.
- DST
Display address as DST-base-relative values.
- Q
Display address as Q-relative values.
- S
Display address as S-relative values.
If the window is jumped to a data segment other than the stack data segment (SDST), only DST mode is allowed. Addresses entered with the QJ and SJ commands are interpreted
based on the mode of the respective window. - signed
This parameter indicates if addresses are to be displayed as signed or
unsigned values. If no value is specified, UNSIGNED is the default. The following values are allowed: - UNSIGNED
Display address as unsigned values (initial setting).
- SIGNED
Display address as signed values (+/- present in address).
Examples | |
Set the Q window to display addresses as DST-relative (stack-base relative)
values. Set the S window to have addresses displayed as signed values. Limitations, Restrictions | |
none |
