To run I7DB8CNV, do the following:
Enter RUN DBUNLOAD.PUB.SYS to unload the database to tape:
Enter RUN DBUTIL.PUB.SYS,ERASE to erase the database data.
Enter RUN I7DB8CNV to convert the data and reload it into the database.
I7DB8CNV will request the following information:
The 7-bit national substitution set where the conversion is
to be made.
Whether or not to convert all data fields of
type X or U. Enter YES or Return to convert the data fields.
Otherwise, enter NO and follow the prompts to specify
each field of type U or X.
The single field in an automatic data set is not proposed for
conversion. Whether or not its values are converted depends
on the response to the item(s) it is linked to for detail
data set(s). At the end of each data set, the user
is asked to confirm that the correct fields to be converted from that
data set have been selected. Again, a Return is a YES answer,
an N allows the user to change the data fields in the data set to
be converted.
I7DB8CNV then loads the database from tape.
As each record is read, those fields which were selected
have their data converted according to the algorithm for the 7-bit
national substitution set selected at the beginning of the program.
I7DB8CNV will not allow 8-bit data (bytes with the high-order bit
set) in the data fields it is trying to convert.
The utility will not abort, but the field in question will not
be converted, and the following warning will be issued:
8-bit data encountered in item [itemname in DS data set]
|
If the program should abort for any reason during the conversion,
the user must log on again to clear the temporary files used
during the conversion process before running the program again.
Following is the dialog from a sample run of the I7DB8CNV utility.
RUN I7DB8CNV.PUB.SYS
HP European 7-bit character sets are:
1. SVENSK/SUOMI
2. DANSK/NORSK
3. FRANCAIS
4. FRANCAIS M
5. DEUTSCH
6. UK
7. ESPANOL
8. ESPANOL M
9. ITALIANO
From which character set should conversion be done: 2
WHICH DATA BASE: QWERTZ
Convert all fields of type U,X in all data sets (Y/N)? N
Data Set SET1 fields to be converted:
ITEM1 (Y/N)? Return
ITEM2 (Y/N)? Return
ITEM3 (Y/N)? N
ITEM4 (Y/N)? Return
Is Data Set SET1 correctly defined (Y/N)? Return
Data Set SET2 - Automatic Master
Data Set SET3 fields to be converted:
ITEM1 (Y/N)? Return
ITEM5 (Y/N)? N
ITEM6 (Y/N)? N
Is Data Set SET3 correctly defined (Y/N)? Return
DATA SET 1: 19 ENTRIES
DATA SET 2: 0 ENTRIES
DATA SET 3: 25 ENTRIES
END OF VOLUME 1, 0 READ ERRORS RECOVERED
DATA BASE LOADED
END OF PROGRAM
:
|
