DISPLAY

Lists a procedure which is stored in the current Proc-file.

Syntax

D[ISPLAY] procedure name [ m [,n]

                           ,file name]

For example:

   >D PROCA,2,4

Where procedure name = PROCA, m = 2, n = 4

      >DISPLAY GETIT

Where procedure name = GETIT

      >DISPLAY REP4,FILEB

Where procedure name = REP4, file name = FILEB

Parameters

procedure name: is the name of a procedure in the current Proc-file. Refer to Table 2-2 “Procedure Commands” for a list of commands which can be used in procedures.
m and n: are the first and last line of the procedure (respectively) to be displayed. m must be an integer less than or equal to n and greater than or equal to 1.
file name: is the name of an MPE ASCII file into which the displayed procedure is to be written.

Discussion

When you use this command, QUERY searches the current Proc-file for the named procedure. If the procedure does not exist or if no Proc-file has been declared, you are informed and prompted for another command.

If the procedure does exist, it is listed with line numbers for reference when editing the procedure with the ALTER command. If line numbers (m,n) are included in the DISPLAY command, only those lines specified will be listed. If only m is included, the procedure will be listed from line m to the end of the procedure.

Displaying to a File

If a file name is included in this command, QUERY writes the procedure statements (excluding line numbers and header which appear as part of the procedure listing) to the specified file. The entire procedure must be transferred. Any existing information in the file is overwritten.

If you have access to save files and file name does not exist in your log-on group, QUERY creates a new file using file name as the formal designator (name of the file). The file size will be 200 records. The maximum Proc-file record size is 125 words. The following message is printed when this situation occurs.

   FILE DOES NOT EXIST, BEING CREATED

Example

      >DISPLAY FIND1,FINDSET 

      >DISPLAY FIND1



      PROCEDURE: FIND1



      001   FIND

      002   CUSTOMER.ACCOUNT IS ""

      003   END

In the example above, the FIND1 procedure is written to file FINDSET. Then FIND1 is listed on the terminal.

      >OUT=LP

      >D FINDCH

      >OUT=TERM

      >D FINDCH





      PROCEDURE: FINDCH



      001   FIND CHAIN

      002   CUSTOMER.ACCOUNT,SALES.ACCOUNT

      003   IS "" END

When OUTPUT=LP, the list is printed on the QSLIST device. When OUTPUT=TERM, the list is printed on the terminal.

      >D FINDCH,2





      PROCEDURE: FINCH



      002   CUSTOMER.ACCOUNT,SALES.ACCOUNT

      003   IS "" END

A single line or a range of lines can be displayed.