 |
» |
|
|
|
In case of unexpected interruption due to hitting BREAK or a terminal power failure, control returns to MPE. To
recover from such a situation, you take the following steps: Perform a hard reset. On an HP 264X terminal, you press
the RESET TERMINAL key twice, and then press RETURN to display the colon prompt, On HP 262X, HP 239X, and HP 150 terminals, you press SHIFT CONTROL RESET and then press RETURN to display the colon prompt.
If echo is turned off, press ESCAPE, then press : to restore echo. Type RESUME and you should see the message READ PENDING. Press REFRESH to return to the menu at which you were interrupted.
The menu will be cleared to initial or previously entered
values. To insure against damage to the file, reenter the information
on all menus pertaining to the form you were creating, modifying,
or entering data at the time of interruption. If you were in the unformatted portion of a FORMSPEC Field
Menu, the procedure is slightly different, as follows: Perform a hard reset, as described above. Type CONTROL R ABORT CONTROL R (Letters must be upper case as shown). If echo is turned off, press ESCAPE, then press : to restore echo. Issue the RUN command for FORMSPEC to continue operation.
|
