Copy the Sample File

Network information is stored in a configuration file called NMCONFIG.PUB.SYS. If you do not already have a NMCONFIG.PUB.SYS file, create a copy of NMCONFIG.PUB.SYS from the sample configuration file supplied on the HP 3000, NMSAMP1.PUB.SYS.

To copy NMSAMP1.PUB.SYS into NMCONFIG.PUB.SYS, enter these commands at the MPE/iX prompt (:):

     HELLO MANAGER.SYS,PUB

     FILE CONFIG=NMCONFIG.PUB.SYS;DEV=1

     FCOPY FROM=NMSAMP1.PUB.SYS;TO=*CONFIG;NEW

	CAUTION: If ANY other configuration file is copied to NMCONFIG.PUB.SYS NMCONFIX.PUB.SYS then dynamic configuration will be disabled until a DTS shutdown and restart is done or the system is rebooted. This includes other files from the same system or files copied from other systems.

	NOTE: "DEV=1" must be specified in the FILE equation to specify that the NMCONFIG.PUB.SYS file is to be stored to system disk 1.