HPlogo Configuring Systems for Terminals, Printers, and Other Serial Devices: HP 3000 MPE/iX Computer Systems > Chapter 6 Configuring Serial Devices (for PC-Based Management)

OpenView DTC Manager and NMMGR
» 

Technical documentation

Complete book in PDF
» Feedback

 » Table of Contents

 » Glossary

 » Index

spacerspacerspacer
spacer
spacer
  		 
 

When the system is configured for PC-Based management, there are several parameters configured in NMMGR that must match corresponding parameters configured in the OpenView DTC Manager. For each DTC that is to have access to the system using nailed devices there must be a corresponding DTC configured on the OpenView DTC Manager. The corresponding DTC is the DTC that has the same DTC Node Name in NMMGR and the OpenView DTC Manager. The following is a list of those parameters that must match and the step where the parameter is configured in NMMGR:

  • The HP 3000's node name configured in step 3 must match the default destination for any DTC ports configured as non-switched terminals or DTC ports configured as dedicated printers.

  • The DTC's node name configured in step 6 must be configured for a corresponding DTC on the OpenView DTC Manager.

  • The DTC's card types and configuration, configured in steps 6 and 7 must match the configuration of a corresponding DTC on the OpenView DTC Manager.

  • The PAD device name and the PAD device type, if one is specified, that is configured in step 7, subsection Configure X.25 card, must match the PAD device name and type configured on the PAD access screen on the OpenView DTC Manager.



Chapter 6 Configuring Serial Devices (for PC-Based Management)
  		 


Copy the Sample File  
Feedback to webmaster