To run NMMGRVER,
logon as MANAGER.SYS
in the PUB group
and run the utility by entering NMMGRVER
after the MPE/iX prompt. NMMGRVER
will prompt you for the configuration file name. Enter NMCONFIG,
and Y to the
confirmation prompt.
The steps to run NMMGRVER
are shown here:
| | : HELLO
MANAGER.SYS,PUB |
| |
| NM Configuration File Conversion Utility 32098-20016
B.04.07 (C) Hewlett-Packard Co. 1988 |
|
| Utility to convert NM configuration files to be
compatible with NMMGR B.04.07. |
|
| ****************************************************
****************************************************
* BE SURE TO STORE BACK UP *
* Copies of Config Files BEFORE Conversion *
****************************************************
**************************************************** |
| Fileset to scanned? NMCONFIG
OK to convert NMCONFG? Y
Backup file is NMBACKn; temporary file is Nxxxx.
** Converting MPE iX config file ** |
| The configuration for the DTS subsystem has been
updated. If this file will be used as NMCONFIG.PUB.SYS,
you must restart the DTS subsystem for the
configuration to take effect. (NMMGRVERMSG 102) |
| CONVERSION completed successfully. (NMMGRVERMSG 0) |
|
NMMGRVER
generates a backup copy of you old configuration file under file
name NMBACKn,
(where n starts
with A, then B, C, and so on, for multiple backup copies). It also
creates a temporary file Nxxxx,
that is purged upon completion of NMMGRVER
conversion.
After converting the network configuration file with NMMGRVER,
you then run NMMGR if needed to modify the DTS subsystem to fit
your actual hardware configuration. Follow the steps described in
Chapter 5 “Configuring Serial Devices (for
Host-Based Management)” for modifying
you network configuration file.
