Obtains status information about a particular port.
Description |
 |
When this subcommand is entered, a large amount of information
related to the port is printed on the terminal.
The following is a brief explanation of key fields displayed
on the terminal:
Revision Number.
Provides version number of SIC hardware and software.
Current Host Name. If a connection
is active, and it was initiated by the terminal, then this is the
name of the host to which the port is connected. Otherwise, this
field is blank.
Port Type. The type of DTC
connector card attached to the port.
Connection State. The status
of the connection between the port and the MPE/iX system. Possible
values are:
Disconnected.
Port is not in use; no MPE/iX session is active on this port.
Connect from AFCP Pending.
MPE/iX has requested and is awaiting a connection to this port.
Connect from DIODAM Pending.
Device has requested and is awaiting a connection to the MPE/iX.
Connected. The port is connected
to an MPE/iX system.
Disconnect from AFCP Pending.
MPE/iX has requested and is awaiting disconnection from the port.
Disconnect from DIODAM Pending.
Device has requested and is awaiting disconnection from MPE/iX.
Bad. The port has failed
its selftest, or this is a non-existent port on the SIC.
The remaining fields contain detailed diagnostics information
for use by HP support representatives. Further explanation of these
fields is beyond the scope of this manual.
