SNA NRJE/V and SNA NRJE/iX Configuration

JES2 Requirements (SNA NRJE)

The JES2 configuration consists of defining the remote workstation to JES2 in a configuration file. JES2 requires (either specifically or by default) that the following information be defined for each workstation:

Table 2-1 contains the parameters and values required by Hewlett-Packard for SNA NRJE for JES2 version 4.1 and earlier versions. For programmers experienced in configuring 8100 DPPX/RJE workstations and 3770 workstations, the table provides most of the needed information. For more information, see the parameter descriptions at the end of this chapter.

JES3 Requirements (SNA NRJE)

The JES3 configuration consists of defining the remote workstation to JES3 in a configuration file. JES3 requires (either specifically or by default) that the following information be defined for each workstation:

JES3 macro and operand values for SNA NRJE should be coded as though a DPPX/RJE 8100 SNA workstation were being installed. Table 2-2 contains the parameter and values required by Hewlett-Packard for SNA NRJE. For more information, see the parameter descriptions at the end of this chapter.

VSE/POWER Requirements (SNA NRJE)

The VSE/POWER configuration consists of defining the remote workstation to VSE/POWER in a configuration file. VSE/POWER requires (either specifically or by default) that the following information be defined for each workstation:

VSE/POWER macro and operand values for SNA NRJE should be coded as though a DPPX/RJE 8100 SNA workstation were being installed. Table 2-3 contains the parameters and values required by Hewlett-Packard for SNA NRJE. For more information, see the parameter descriptions at the end of this chapter.

	NOTE: Parameters that are not listed in table 2-3 can be entered at your discretion. There are no restrictions on them beyond what is required for DPPX/RJE on the IBM 8100.