 |
» |
|
|
|
To run SNA NRJE on your HP 3000, you and your
HP representative must install the product and configure both your
HP 3000 environment and the host system to support SNA NRJE. As
part of the configuration process, you must ensure that the HP 3000
parameters match those on the host side. The necessary parameters
are described in Chapter 3 “SNA NRJE Configuration” of this manual. This chapter assumes that installation tasks are divided between
you (the node manager) and your HP representative. Before the HP representative arrives to install SNA NRJE on
the HP 3000, you must do the following: Ensure that the modem link operates
between the HP 3000 and the host. If you use HP modems, Hewlett-Packard
will help you verify that these modems work. Configure the host according to the procedures detailed
in the HP SNA Products guides (see the list
of related publications in the preface of this manual). Be sure to obtain a copy of the host system generation.
Your HP representative will need this information later during SNA
NRJE installation. Ensure that the host system has the hardware and
software requirements as listed in the SNA NRJE User/Programmer Reference
Manual. Ensure that the SNA link product has been installed
by an HP representative. Remember, the SNA link product includes
hardware (the INP and cable [for SNA Link/V] or the PSI and cables
[for SNA/SDLC Link/XL and SNA/X.25 Link/XL]) and software (SNA Transport).
| | | |  | NOTE: Although SNA NRJE and SNA IMF can use the same SNA link,
you must configure each service. For example, if you are installing
SNA NRJE on a system that has SNA IMF, you must configure workstations, logical
readers, logical writers, and so forth. Also, SNA NRJE and SNA IMF
require separate Logical Units (LUs). For example, to use the same SNA
link, you should devote LUs W through X to SNA NRJE and LUs Y through
Z to SNA IMF, or vice versa. | | | | |
After you do these preliminary installation tasks, your HP representative
takes over and completes the installation of the software required
for using SNA NRJE. Your HP representative installs the NRJE software
and changes the I/O configuration, if needed. |
