This chapter contains information you need to know about installation
of the SNA link products.
To run an SNA link product on the HP 3000, you must install
the product, and then your Hewlett-Packard
support contact must configure your HP 3000 environment to support
the product.
Before the Hewlett-Packard support contact arrives to do the minimum
configuration of the SNA link product on the HP 3000, you must do
these things:
Ensure that the remote system has the required hardware
and software as listed in chapter 1 of this manual.
Ensure that the remote system has been configured according
to the procedures detailed in the ACF/NCP and ACF/VTAM Guide Host
System Programmer's Reference or the AS/400 Guide Host System
Programmer's Reference.
Obtain a copy of the new remote system configuration listing;
your Hewlett-Packard support contact will need this information later
during the minimum configuration of the SNA link product.
Ensure that the modem link between the HP 3000 and the
remote system is operational.
Ensure that the HP 3000 is at the proper release level.
Use the AUTOINST utility to load the SNA link product software. See
the HP 3000 MPE XL Installation and Update Manual (36123-90001)
or the HP 3000 MPE XL Add-On Manual (36123-90003) for more
information.
Run NMMAINT to ensure that all of the necessary software
modules have been successfully installed by AUTOINST and are at the
correct version levels.
After you do these installation tasks, your Hewlett-Packard support
contact installs the PSI card and completes the minimum configuration
required to verify minimum SNA link product functionality.
