In this section you set a staging
area, that is, you select the staging area that the system will
boot and operate from on the next reboot. This activity requires
system manager capabilities.
To set a staging area:
Log
on from the console (if you are not already logged on)
and start the spooler and streams device.
:HELLO MANAGER.SYS,INSTALL;HIPRI
:LIMIT 1,1
:SPOOLERprint_device;START
:STREAMSstreams_device |
Common print_device
values are LP or 6. A common streams_device
value is 10.
Ignore the group out of connect time
warning, if it displays.
Start HP Stage/iX:
Set the staging area the system will boot and operate
from:
STAGEMAN> SET STAGE=stage_name |
where stage_name
is the name of the staging
area that contains the patches and operating system changes you
are making.
Refer to Appendix G “HP Stage/iX Reference”
for additional information on the HP Stage/iX commands.
 |
| |
|
 | NOTE: The changes do not take place until the next reboot.
In other words, the staging area is not activated until boot time
(section 5.14). |
|
| |
|
Setting a Staging Area
completed. Go to the next section on your checklist.
