HPlogo HP 3000 MPE/iX Release 6.0 System Software Maintenance Manual (Release C.60.00): HP 3000 MPE/iX Computer Systems > Chapter 4 Preparing Your System

4.4 Initializing HP Stage/iX

» 

Technical documentation

Complete book in PDF
» Feedback

 » Table of Contents

 » Glossary

 » Index

HP Stage/iX is part of the FOS. It is installed when the system software is updated to version 5.5 or 6.0. You must be on version 5.5 or greater before you can use HP Stage/iX. You cannot use HP Stage/iX to update from version 5.5 to 6.0.

NOTE: Not all patches are stageable. At the time of release 6.0, Stage/iX cannot handle patches which involve System configuration files, MMSAVE.MPEXL.SYS, nonsystem volume set files, and patches with files that contain jobs that are streamed during patch installation. Patches will be identified as stageable or not stageable during the installation process.

To initialize HP Stage/iX:

  1. Determine if HP Stage/iX is already initialized.

    :STAGEMAN STATUS

    The following message displays if HP Stage/iX is not initialized:

    The HP Stage/iX environment is not initialized.
  2. If it is not initialized, type at the MPE/iX colon prompt:

    :STAGEMAN INITIALIZE

    The following message displays when HP Stage/iX initializes:

    Successfully initialized the HP Stage/iX environment.
    • Initializing HP Stage/iX completed. Proceed to the next section on your checklist.

Feedback to webmaster