Checklist I. Modify Remote System

Use this task checklist if your source material was on CD-ROM and you are now using a CSLT tape to:

Update your remote system software version and applying PowerPatch patches




	NOTE: Before performing the activities in this checklist, you must have completed the appropriate activities on the checklist H, "Update with CD-ROM." For each remote system you are modifying, complete the activities in this checklist. You cannot apply Reactive patches at the same time you are updating the system. You must apply Reactive patches after you update the remote system. To apply Reactive patches (after you update the system) refer to Checklist A, "Manage Patches," or Checklist B, "Manage Patches by Staging Area."

Print a copy of this checklist for each remote system that you are updating.

Read and perform the steps only in the following sections on your remote system:

Begin Preparation Tasks. Does not require exclusive access to the system.

Log onto your remote system.

Chapter 3 “Planning for Your Task”
- 3.1 Verifying Required Materials
- 3.2 General Planning Tasks
- 3.4 Checking Tape Media
- 3.5 Checking Peripherals
- 3.6 Estimating Disk Space
Chapter 4 “Preparing Your System”
- 4.12 Reserving Disk Space for CD-ROM Tasks
  Record contiguous disk space:
  Record non-contiguous disk space:

Preparation Tasks completed. Schedule downtime for exclusive access.

Begin Exclusive Access Tasks.

Checklist I tasks completed.

If you have Reactive patches to apply, proceed to one of these checklists:

Record system change:

Technical documentation