Use this task checklist if your source material is on tape
and you are using a CSLT tape to:
Update your
system software version level
 |
| |
|
 | NOTE: You cannot apply Reactive patches at the same time you
are updating the system. You must apply Reactive patches after you
update the system. To apply Reactive patches (after you update the
system) refer to Checklist A, "Manage Patches,"
or Checklist B, "Manage Patches by Staging Area." |
|
| |
|
Print a copy of this checklist for each system that you are
updating.
Read and perform the steps only in the following sections:
Begin Preparation Tasks. Does not require exclusive access to the system.
Chapter 3 “Planning for Your Task”
3.1 Verifying Required Materials
3.2 General Planning Tasks
3.6 Estimating Disk Space
Record contiguous disk space:
Record non-contiguous disk space:
Preparation Tasks completed. Schedule downtime for exclusive access.
Begin Exclusive Access Tasks.
Chapter 5 “Modifying Your System”
5.1 Securing and Backing Up the System for Tape
Tasks
Record terminated logging processes:
Record system files with lockwords:
Record temporary filename for the COMMAND.PUB.SYS
file:
5.7 Creating the CSLT Using AUTOINST—Select option 3 FOS, SUBSYS, PowerPatch if you have a PowerPatch tape, or if no PowerPatch, select option 4 FOS and SUBSYS.
Record manually installed products:
Record data communication products:
5.13 Applying the CSLT Modification
5.14 Restarting the System
5.15 Rerunning AUTOINST—Required only if applying PowerPatch.
Chapter 6 “Finishing the Process”
6.1 Configuring Datacomm and UPS
6.4 Setting Passwords, Lockwords, and UDCs
6.5 Configuring and Updating Manually Installed
Products
6.6 Setting Up the TAR Utility
6.7 Performing the Final Reboot
6.8 Restarting Selected System Functions
6.9 Backing Up Your System
Checklist G tasks completed.
If you have Reactive patches to apply, proceed to either one
of these checklists:
Checklist A, "Manage Patches"
Checklist B, "Manage Patches by Staging
Area"
Record system change:
