HPlogo HP-UX iSCSI Software InitiatorRelease Notes: Revision B.11.11.03e for HP-UX 11i v1Revision B.11.23.03e for HP-UX 11i v2 September 2004 (or later) > Chapter 1 HP-UX iSCSI Software Initiator Release Notes

Announcement

» 

Technical documentation

Complete book in PDF

 » Table of Contents

The HP-UX iSCSI Software Initiator is a software implementation of the iSCSI protocol (RFC 3720) based on the HP-UX host TCP/IP stack. The iSCSI protocol defines a mass storage transport wedge between TCP and the SCSI Services layer. The HP-UX iSCSI Software Initiator is compliant with RFC 3720. To access the IETF iSCSI Specification RFC 3720, go to:

http://www.ietf.org/rfc/rfc3720.txt

The HP-UX iSCSI Software Initiator consists of two modules, the iSCSI Transport Driver and the iSCSI Software Interface Driver.

  • The iSCSI Transport Driver is the Session management module.

  • The iSCSI Software Interface Driver module interfaces with the host based TCP/IP module.

The following information is for revisions B.11.11.03e and B.11.23.03e of the HP-UX iSCSI Software Initiator.

NOTE: The HP-UX iSCSI Software Initiator revision B.11.23.03e is supported on HP servers running HP-UX 11i v2 September 2004 or later.

The HP-UX iSCSI Software Initiator revision B.11.23.03e is not supported on HP-UX 11i v2 versions preceding HP-UX 11i v2 September 2004.

  • The HP-UX iSCSI Software Initiator requires no changes to applications that access mass storage devices.

  • The HP-UX iSCSI Software Initiator revision B.11.11.03e is supported on any of the 64 bit HP 9000 series servers running HP-UX 11i v1.

    Network interface cards (NICs) and network infrastructure components currently supported with HP-UX 11i v1 are required. NICs with 1 Gigabit or greater transfer rates are strongly recommended.

  • The HP-UX iSCSI Software Initiator revision B.11.23.03e is supported on any of the HP Integrity servers running HP-UX 11i v2 September 2004 or later and on any HP 9000 series servers running HP-UX 11i v2 September 2004 or later.

    Network interface cards (NICs) and network infrastructure components currently supported with 11i v2 September 2004 or later are required. NICs with 1 Gigabit or greater transfer rates are strongly recommended.

  • For instructions on locating, downloading and installing the HP-UX iSCSI Software Initiator, see the HP-UX iSCSI Software Initiator Support Guide.

Table 1-1 HP-UX iSCSI Software Initiator Documentation Availability

Document Title

Part Number

url

HP-UX iSCSI Software Initiator Support Guide

T1452-90011

http://www.docs.hp.com
See: “iSCSI (SCSI Over TCP/IP)” in the “Networking & Communications” section.

HP-UX iSCSI Software Initiator Release Notes Revision B.11.11.03e and 11.23.03e, E0705

T1452-90010

http://www.docs.hp.com
See: “iSCSI (SCSI Over TCP/IP)” in the “Networking & Communications” section.

HP-UX iSCSI Software Initiator Support Matrix

N/A

http://www.docs.hp.com
See: “iSCSI (SCSI Over TCP/IP)” in the “Networking & Communications” section.