HP 3000 Manuals

To list your system hardware [ HP 3000 Series 9X8LX Computer Systems Getting Started ] MPE/iX 5.0 Documentation


HP 3000 Series 9X8LX Computer Systems Getting Started

To list your system hardware 

Before you start your system, you may want to use the MAPPER utility.
Once initiated, MAPPER displays a user interface that gives you
information about your disk drives, memory, processors and co-processors
and allows you to modify any information that you need to change.  To run
MAPPER from the ISL prompt:

   1.  Type the following at the ISL prompt to get an ODE prompt:

            ISL> ODE 

   2.  Type the following at the ODE prompt to get a MAPPER prompt:

            ODE> MAPPER 

   3.  At the MAPPER prompt type:

            MAPPER> RUN 

       To exit MAPPER after you modify or accept the information
       displayed, you must exit out of MAPPER and ODE to get back to the
       ISL prompt.  For example:

            1.  MAPPER> EXIT

            2.  ODE> EXIT

            3.  ISL>

       _________________________________________________________________ 

       NOTE  To use MAPPER after you have started up your system, you
             must first stop all system activity and shut the system
             down, for example, at the system console prompt:

                  : [ [CTRL]] A 
                  =SHUTDOWN 

             Once the system issues the final shutdown message, transfer
             control by entering:

                   [ [CTRL]] B 

             If this reply does not work, initiate a hard reset by
             entering:

                  CM> RS 

             Then, at the ISL prompt, proceed as above (Step 1) to run
             MAPPER.

       _________________________________________________________________ 



MPE/iX 5.0 Documentation