HP 3000 Manuals HP 3000 Manuals
Prepare the PC Client
Before you install PC API on the PC client, complete the following steps:
* Install the supporting software.
* Check the networking configuration.
Install the Supporting Software
When you install supporting software on the PC client, follow the order
specified below.
1. MS-DOS Operating System
2. Memory management software (optional)
3. Networking software
_________________________________________________________________
CAUTION If you are upgrading the LAN software, follow the
instructions provided with the LAN software to ensure
that network addresses configured for a previous release
are not lost when the current release is installed.
_________________________________________________________________
4. Microsoft Windows
5. Application software
For specific instructions about installing each piece of supporting
software, refer to that product's installation guide.
Check the Network Configuration
If you are using TCP/IP protocol, do the following steps:
* Type netsetup at the DOS prompt.
* Select Reconfigure network software.
* Check that NetIPC or sockets are configured, depending on the one
you are using.
* Change the Socket Buffer size to 9600 or greater.
* Set demand load=NO.
* If you are using Sockets (ARPA), ensure that the number of Socket
Sessions is greater than or equal to the number of concurrent
connections that you expect to use.
* If you are using NetIPC (NS), ensure that the number of NetIPC
Sessions is greater than or equal to the number of concurrent
connections that you expect to use.
If you are using SPX/IPX protocol, refer to the manual, NetWare for the
HP 3000 Installation.