HP 3000 Manuals HP 3000 Manuals
Printer and Disc Diagnostic This section lists messages generated by the Resource Sharing Host Diagnostic as the diagnostic tests are run. PD 601 HP Resource Sharing verified correctly. Version number The Verification Test was successful. The number given is the composite version number. PD 602 Test Successful PD 603 This feature is not yet supported! This test is not available for Resource Sharing. PD 604 No modules in message catalog; incorrect catalog Modules to be version checked were not found in the message catalog, which may have been corrupted. Restore the correct message catalog and try again. PD 605 Module kind incorrectly described in catalog The message catalog is corrupted, or the wrong catalog is being used. Restore the correct message catalog and try again. PD 606 Cannot open message catalog; status number The message catalog is missing. Restore the correct message catalog and try again. PD 607 Module missing version number; product version number The diagnostic has found a module that does not have a version number. Run the diagnostic in command mode to identify the module that is missing the number. Reinstall the module. PD 608 Incompatible version numbers; product version number The Verification Test has found incompatible version numbers. Reinstall the module with the bad version number. PD 609 Error returned from Diagnostic Interface #HDI error number An internal error has been returned from the Host Diagnostic Interface. Respond to the HDI error number and try again. PD 610 Go/No Go Test Successful PD 611 Go/No Go Failed; See Failure Analysis above Study the Failure Analysis text for corrective action. PD 612 Go/No Go Failed; Refer to file name for Failure Analysis Refer to the file named in the error message for more detail about the failure. PD 613 Go/No Go Subtest "name" successful The Resource Sharing subtest named in the message was successful. PD 614 Message catalog access failure The message catalog has been corrupted or the program has accessed the wrong catalog. Restore the correct message catalog and try again. PD 615 Go/No Go successful; Should use logon username.account This is a status message only. PD 616 - PD 900 Not used. PD 901 Cannot accomplish a connection to the shared disc Incorrect installation of Resource Sharing. With the RESMGR.PPC.SYS program, verify that there is a shared disc on the group PPC in the SYS account, and that there is a share DIAGDISC outstanding. The share for DIAGDISC must be defined as: * A block device share * RWC attributes * Pointing to the group and account PPC.SYS * No password PD 902 Creation of data file unsuccessful Resources are exhausted. With the RESMGR.PPC.SYS program, verify that that there is a share for DIAGDISC outstanding. The share for DIAGDISC must be defined as: * A block device share * RWC attributes * Pointing to the group and account PPC.SYS * No password Increase any file size limitation on the group PPC. Verify that the system has enough free disc space. PD 903 Data file created, accessed but could not be closed Resources are exhausted. With the RESMGR.PPC.SYS program, verify that the sharename DIAGDISC is correct. The share for DIAGDISC must be defined as: * A block device share * RWC attributes * Pointing to the group and account PPC.SYS * No password Increase any file size limitation on the group PPC. Verify that the system has enough free disc space. PD 904 Not used. PD 905 Data created & accessed, but disconnect failed Resource Sharing system error. Note the steps you were performing when the error occurred, then contact your HP representative. PD 906 Attempting to make a connection to "LP" for printer testing Device LP incorrectly configured. Use RESMGR to verify that a share exists for LP (choose ~~SHARE STATUS f5). PD 907 Creating the print data file Incorrect installation or out of disc space. Use the Version Check (verification test) diagnostic to verify that all components of Resource Sharing are present. Verify that there is sufficient free disc space. PD 908 Writing data to the printer data file Out of disc space or incorrect installation. Free more disc space. Use RESMGR to verify that there is a share outstanding for LP (choose ~~SHARE STATUS f5). PD 909 Print file created, but close was not successful Resource Sharing system error. Write down the error number and message, then contact your HP representative. PD 910 Print file created, but disconnect failed Resource Sharing system error. Contact your HP representative. PD 911 Data file created, but write was unsuccessful Out of disc space or incorrect installation. Free up more disc space. Use RESMGR to verify that a share exists for DIAGDISC. The share for DIAGDISC must be defined as: * A block device share * RWC attributes * Pointing to the group and account PPC.SYS * No password PD 912 Data file created & written to, but read failed Incorrect installation of Resource Sharing product. Use RESMGR to verify that a share exists for DIAGDISC. The share for DIAGDISC must be defined as: * A block device share * RWC attributes * Pointing to the group and account PPC.SYS * No password PD 913 Directory creation failed Out of disc space or incorrect installation of Resource Sharing. Use RESMGR to verify that a share exists for DIAGDISC. It should be defined as: * A block device share * RWC attributes * Pointing to the group and account PPC.SYS * No password Increase any file size limitations on the group PPC.SYS. Verify that there is sufficient free disc space. PD 914 Directory created but could not be deleted Resource Sharing system error. Write down the error number and message, then contact your HP representative. PD 915 Print class "LP" does not have a device assigned to it Incorrect installation of Resource Sharing product. Make sure you have set up LP as an MPE class name. Next, use RESMGR to verify that a share exists for LP (choose ~~SHARE STATUS f5). PD 916 No default Server logon string Logon string for the Resource Sharing server is incorrect. Use RESMGR to correct the configuration information for LOGON. PD 917 Invalid Server logon string Logon string for the Resource Sharing server is incorrect. Use RESMGR to correct the configuration information for LOGON. PD 918 Invalid Server logon string; non-existent account Logon string for the Resource Sharing server is incorrect. Use RESMGR to correct the configuration information for LOGON. PD 919 Invalid Server logon string; non-existent user Logon string for the Resource Sharing server is incorrect. Use RESMGR to correct the configuration information for LOGON. PD 920 Invalid Server logon string; no home group Logon string for the Resource Sharing server is incorrect. Use RESMGR to correct the configuration information for LOGON. PD 921 Invalid Server logon string; incorrect password Logon string for the Resource Sharing server is incorrect. Use RESMGR to correct the configuration information for LOGON. PD 922 Cannot create server process (PSERVER.PPC.SYS) The server program is absent. Restore the server program from current system backup tape.