HP 3000 Manuals HP 3000 Manuals
Setting Up Additional Software Products
Your system may have additional software products that require special
set up attention. You must do this from MANAGER.SYS. To determine if
your system has additional software products, follow these steps:
1. To see if you are in MANAGER.SYS, type:
: SHOWME Return
________________________________________________________________________
| |
| |
| USER: #S9749, MANAGER.SYS, PUB |
| RELEASE: v.uu.ff MPE/iX HP31900 v.uu.ff |
| CURRENT: Day, Month, Year, Time |
| LOGON: Day, Month, Year, Time |
| CPU SECONDS: 2 CONNECT MINUTES: 1 |
| $STDIN LDEV: 32 $STDLIST LDEV: 32 |
| |
________________________________________________________________________
Your screen displays information about your logon identity on the
first line to let you know if you are currently in MANAGER.SYS.
If you are not in MANAGER.SYS, use the HELLO command to log on as
MANAGER.SYS
:HELLO MANAGER.SYS Return
2. At the system prompt (:), enter the LISTFILE command to find out
if the file SPNAMES exists on your system.
:LISTFILE SPNAMES Return
If no file is found, you have not purchased any of the software
that requires special set up attention, and you can proceed to the
next chapter.
3. If a file is found, enter the following command to display the
contents of the file to the screen. Write down the names of these
products.
:PRINT SPNAMES Return
4. Refer to the manual Preparing Additional Software Products for Use
on the HP 3000 Series 9X7LX (36123-90014) for details about the
products listed in your SPNAMES file. The manual contains the
procedures needed to complete the installation process of those
products listed in the SPNAMES file.