HP 3000 Manuals HP 3000 Manuals
Configuring Memory
Coverage for memory boards is configured through the psconfig Configure
Memory Menu, which can be reached from the Main Menu or from the
Configuration Options Menu.
* From the Main Menu: Type 4 4 or configure memory.
* From the Configuration Options Menu: Type 4 or memory.
This displays the Configure Memory Menu:
______________________________________________________________________________
| |
| |
| |
| |
| ********************************************************************* |
| |
| M (MainMenu) P (PreviousMenu) R (Refresh) H (Help) E (Exit) |
| |
| Configure Memory Total boards: 3 |
| |
| Enabled/ |
| Memory Board Disabled Size |
| |
| 1 - BusID:ControllerSlot.ArraySlot: 1022:2. enabled 16Mb |
| 2 - BusID:ControllerSlot.ArraySlot: 1022:3. enabled 16Mb |
| 3 - BusID:ControllerSlot.ArraySlot: 1022:4. enabled 16Mb |
| |
| |
| No more boards to display. |
| |
| Type an item number, an item key, or a command: |
| |
______________________________________________________________________________
Figure 4-7. Configure Memory Menu
This menu displays a list of the current memory configuration.
* The list may be multi-paged if the system has more than 10 memory
boards. (Only 10 boards are listed at a time. If there are more
boards to list, psconfig prompts you to press Return to display
these boards.)
The memory board number is parsed as follows:
Controller Slot
|
|
1022:2.0
| |
BusID------| |____ Array Slot (if used)
Figure 4-8. Reading Memory Board/Item Key
NOTE For some boards, the array slot may be blank.
To enable or disable coverage of memory boards:
* Type the item number corresponding to the memory board.
* Type e (for enabled) or d (for disabled) when psconfig prompts
you.