HP 3000 Manuals HP 3000 Manuals
Phase 6: Checking System Logging
Run SYSGEN and ensure that logging is "ON" for the following events:
* 100, System logging enabled
* 107, Power fail record
* 111, I/O error record
* 146, Maintenance request log
* 150, Diagnostics information record
* 152, Low priority machine check (LPMC)
Procedures Through SYSGEN: (Figure 2-2 illustrates the following steps.)
1. Log on as manager.sys
2. Type the following at the MPE prompt and press Return:
sysgen
3. Type log at the sysgen> prompt.
4. Type show at the log> prompt. The logging status for all event
numbers should be displayed.
5. Verify that the status for events 107, 111, 146, 150, and 152 is
"ON". If not, change the status.
________________________________________________________________________
| |
| To Change the Status: |
| |
| |
| a. Type the following at the log> prompt and press Return: |
| |
| slog on=event# |
| |
| where event# is 107, 111, 146, 150, or 152 (as appropriate). |
| |
| b. Type hold and press Return. |
| |
| c. Type exit to return to the SYSGEN> prompt. |
| |
________________________________________________________________________
6. Type keep, if you made any changes.
7. Type exit to return to MPE.
NOTE If changes have been made, do not restart the system at this time.
Proceed to "Phase 8: Checking the Datacomm Port Configuration,"
first. This avoids a second restart should changes to the datacomm
port configuration be required. Then, return to "Phase 7:
Determining the HP Predictive Support Run Schedule."
Figure 2-2 illustrates a sample interchange with SYSGEN. Note that
logging for event 146 is changed from "OFF" to "ON". (The shaded text
shows the commands used to reach the display of events.)
___________________________________________________________________________
| |
| |
| : SYSGEN |
| |
| sysgen> log |
| [Log configurator commands are displayed] |
| |
| log> show |
| |
| configurable item max min current |
| -------- ------- ------- |
| # of user logging processes 64 2 64 |
| # users per logging process 256 1 128 |
| |
| system log events event # status |
| ----------------- ------- ------- |
| System logging enabled 100 ON |
| System up record 101 ON |
| Job initiation record 102 OFF |
| Job termination record 103 OFF |
| Process termination record 104 OFF |
| File close record 105 OFF |
| System shutdown record 106 ON |
| Power failure record 107 ON |
| Spooling log record 108 ON |
| I/O error record 111 ON |
| Physical mount/dismount 112 OFF |
| Logical/mount/dismount 113 OFF |
| Tape labels record 114 OFF |
| Console log record 115 ON |
| Program file event 116 ON |
| Chgroup record 143 OFF |
| File open record 144 OFF |
| Maintenance request log 146 OFF |
| Diagnostic information record 150 ON |
| High priority machine check 151 OFF |
| Low priority machine check 152 ON |
| CM file close record 160 OFF |
| log> slog on=146 |
| log> hold |
| log> exit |
| sysgen> keep |
| Keeping to group CONFIG.SYS |
| Purge old configuration (yes/no)? yes |
| |
| sysgen> exit |
| |
___________________________________________________________________________
Figure 2-2. Changing System Logging Status Through SYSGEN: Sample - Event 146