HP 3000 Manuals

HP Performance Collection Software User's Manual (for MPE Systems)

LIST 

LIST [device]

You can change the list device for all EXTRACT reports in two ways:

   *   To issue a file equation before running the EXTRACT program, enter

            :FILE RXLIST;DEV=LP

       or 

   *   Once EXTRACT is running, enter

            LIST LP

The device parameter on the LIST command must represent a valid
configured device on the current HP 3000 system.  It should be a device
that can be written to (normally, this would be a printer).  If you need
to specify more than just the device name, you can issue a file equation
for file RXLIST, then enter the device by using the LIST command.

     MPE FILE RXLIST;ENV=LP2.HPENV.SYS
     LIST HP2680

To return the listing device back to the standard list device, enter

     LIST TERM
     or 
     LIST $STDLIST
     or 
     LIST *

To determine the current list device, enter the LIST command without
parameters as follows:

     LIST

If the LIST device is not $STDLIST, most commands are echoed as they are
entered.

MPE/iX 5.0 Documentation