HP 3000 Manuals

HP TELNET/iX Client Users Guide

Displaying/Setting/Toggling TELNET/iX Client Values 

You can set or toggle TELNET/iX Client variables to specific values.  Use
the DISPLAY command at the telnet> prompt to list the current values of
variables. 

     telnet>  DISPLAY
     will flush output when sending interrupt characters
     won't send interrupt characters in urgent mode
     won't map carriage return on output.
     won't recognize certain control characters.
     won't turn on socket level debugging.
     won't print hexadecimalrepresentation of network traffic.
     won't show option processing.
     [^E]  echo.
     [^]]  escape.
     [^H]  erase.
     [^O]  flushoutput.
     [^Y]  interrupt.
     [^X]  kill.
     [^\]  quit.
     {^D]  eof.
     telnet>

Values shown in this example are default values.  To display the value of
particular SET and TOGGLE variables only, type these arguments after the
DISPLAY command.

Setting TELNET/iX Client Values 

You can set particular TELNET/iX Client variables to specific values
using the SET command.  See Chapter 3 for a summary of the variables that
can be set using this command.  For example, to set the escape character
to [CTRL]-C, type the following at the telnet> prompt: 

     telnet> SET ESCAPE [CTRL]-C

     escape character is `^C'.

You can use the DISPLAY command to verify the new value of the escape
character.

Toggling TELNET/iX Client Values 

You can also toggle particular TELNET/iX Client values using the TOGGLE
command.  See Chapter 3 for a summary of the variables that can be
toggled using this command.  For example, to enable carriage return mode
from its default disabled state (FALSE), type the following at the
telnet> prompt: 

     telnet> TOGGLE CRMOD
     Will map carriage return on output.

You can use the DISPLAY command to verify that carriage return mode is
enabled.

MPE/iX 5.0 Documentation