HP 3000 Manuals HP 3000 Manuals
Operation With the introduction of host-based X.25 networking capabilities, a new command has been added to MPE/iX. This command, DTCCNTRL, allows MPE/ iX system operators to start and stop X.25 system-to-system or PAD connection support, obtain status about whether X.25 or both X.25 and PAD support are up, and dynamically download a specified set of configuration parameters to the card or to the DTC. System Operator (OP) capability is required to use the DTCCNTRL command. Dynamic Reconfiguration Dynamic reconfiguration makes it possible to change a subset of configuration values without resetting and redownloading the DTC. This allows you to modify configurations without impacting all the users accessing the system through that DTC. Obtaining Status The DTCCNTRL Statusfunction displays the current status of each DTC/X.25 Network Access cardinstalled in a specified DTC. Use the Status function to determine whether or not X.25 or PAD support is currently active for a DTC/X.25 Network Access card. See chapter 7 for more information on obtaining status using DTCCNTRL.