HP 3000 Manuals

Configuring and Managing Host-Based X.25 Links

Chapter 6  Configuring X.25 Links Step-by-Step 

This chapter provides step-by-step instructions for configuring X.25 iX
System Access 
for systems using host-based network management.  This manual assumes
that you are using the guided configuration capabilities of NMMGR.

Before using NMMGR to configure a link, you should complete the
worksheets provided.  See chapter 5 for more information on planning your
configuration and filling out the configuration worksheets.

This chapter includes step-by-step instructions to help you perform the
following tasks:

   *   Configure the X.25 iX System Access link.

   *   Configure X.25 virtual circuits.

   *   Configure neighbor gateways, if there are any.


NOTE  If you are configuring X.25 iX System Access on a system using
      PC-based network management (an OpenView workstation is part of the
      network), you should use the HP 3000/iX Network Planning and 
      Configuration Guide (36922-61023) instead of this manual to
      configure the X.25 link.

MPE/iX 5.0 Documentation