HP 3000 Manuals HP 3000 Manuals
Chapter 3 Configuring DTCs Step-by-Step
This chapter provides step-by-step instructions for configuring
Datacommunications and Terminal Controllers (DTCs) for systems using
host-based network management. If you are using this manual to configure
DTCs, it is assumed that X.25 network connections will be part of the
host-based configuration.
Before using NMMGR to configure DTCs, you should complete the worksheets
provided. See chapter 2 for more information on planning your
configuration and filling out the configuration worksheets.
This chapter includes step-by-step instructions to help you perform the
following tasks:
* Configure host information.
* Configure information for each DTC connected to the system.
* Configure information for each direct connect and modem card
contained in any DTC connected to the system.
* Configure information for each DTC/X.25 Network Access card
contained in any DTC connected to the system, including:
* X.25 level 1, 2, and 3 parameters.
* System-to-system local user group information.
* Nailed PAD connections and PAD security.
* Validate your network configuration (SYSGEN cross-validation is
done automatically within NMMGR).
NOTE If you are configuring a system that does not require X.25
system-to-system or PAD configuration, use Configuring Systems for
Terminals, Printers, and Other Serial Devices (32022-61000) instead
of this manual.