HP 3000 Manuals

HP3000/iX Network Planning and Configuration Guide

To Convert NS3000/XL 1.X to 2.0 Files 

The following procedure describes the steps necessary for conversion.

   1.  At the MPE/iX prompt, type:

       Run NMMGRVER.PUB.SYS

   2.  At the prompt, enter the filenames to convert:

       Fileset to be scanned?

       For example, enter NMCONFIG.PUB.SYS, then press [RETURN]. You can
       enter one file name or a set of files in the following form:

            filename[.groupname[.acctname]]
            @[.groupname[.acctname]]
            @.@[.acctname]
            @.@.@

   3.  NMMGRVER creates a backup of the file and displays the following
       message:

       OK to convert filename.groupname.acctname?

       The backup files are named NMBACKA, NMBACKB, and so on.  To
       proceed, enter Y for Yes, then press [RETURN]. Press [RETURN] or
       type N, [RETURN] to exit.

   4.  NMMGRVER displays the following message:

       Backup file is NMBACKY, temporary file is Nnnnn.

   5.  The file conversion proceeds without further input.  When
       complete, the message:

       CONVERSION COMPLETED SUCCESSFULLY

       is displayed.

   6.  Rename the converted file if required.  Make any updates to the
       DTS subystem using NMMGR as required for your installation to
       complete the conversion.  For full details, refer to Configuring 
       Systems for Terminals, Printers, and Other Serial Devices if your
       system uses PC-based network management, or to Configuring and 
       Managing Host-Based X.25 Links if your system uses host-based
       network management.

MPE/iX 5.0 Documentation