HP 3000 Manuals HP 3000 Manuals
To Cross-Validate in SYSGEN
Cross-validationensures that there are no conflicts in the use of node
names, device classes, and physical paths between the data currently
contained in NMCONFIG.PUB.SYS and the system configuration data. To
cross-validate, use the SYSGEN facility (OP capability is required). To
use SYSGEN, type the following commands at the MPE prompt (user input is
underlined):
sysgen
sysgen>io
io>ld {optional}
io>exit
sysgen>exit
The optional ld (list devices) command allows you to verify the NMMGR
devices that are configured.
Cross-validation is done on the KEEP, TAPE, I/O, and RDCC commands in
SYSGEN. For more information, see System Startup, Configuration, and
Shutdown Reference Manual.
If you have completed the configuration process, proceed to chapter 14
titled "Operating the Network".