HP 3000 Manuals

Using NS3000/XL Network Services

Running NetCI 

To run NetCI from the MPE prompt, enter the following:

     : RUN NETCI.PUB.SYS 

Now press Return.

After MPE accepts the  RUN command, NetCI displays a message similar to
the following message:

 NetCI/XL  A.00.00 (c)Copyright Hewlett-Packard Co.  1988

NetCI then displays the NetCI prompt.  This prompt tells you that you are
in NetCI. You can now execute MPE commands and UDCs, and run programs on
any node.  Before you do so, you must configure the nodes and logon
information.  This allows you to access systems through NetCI without
having to manually establish session logons for each node.

To exit NetCI, enter the following:

     NetCI> EXIT (or E)

which returns you to the MPE prompt.

MPE/iX 5.0 Documentation