HP 3000 Manuals

TurboSTORE/XL II User's Guide

RESTORE Syntax 

With the TurboSTORE/XL II program, you use the RESTORE command to restore
to disk.  The RESTORE command syntax is shown below.

RESTORE [restorefile]

[{filesetlist[-filesetlist] [,filesetlist[-filesetlist]] [,...]}]
[{^indirectfile                                                }]

[;DEV=device] [;SHOW=[showoption[,showoption[,...]]]]

                  [ {{LOCAL             }       }]
[;FILES=maxfiles] [;{{GROUP=groupname   } [;...]}]
                  [ {{ACC[oun]T=acctname}       }]

[       [ {GROUP  }      ]]
[;CREATE[={ACCT   }[;...]]] [;CREATOR[=USERNAME]]
[       [ {CREATOR}      ]]

[;{KEEP  }] [;{OLDDATE}] [;LISTDIR] [;ONERR[OR]={QUIT}]
[ {NOKEEP}] [ {NEWDATE}]            [           {SKIP}]

[;FCRANGE=filecode/filecode [,filecode/filecode[,...]]] [;DIRECTORY]

[;VOL=volumename] [;VOLCLASS=volumeclassname] [;VOLSET=volumesetname]

[;RESTORESET=(device[,...])[,(device[,...])[,...]]] [REV

BEG][;MOSET=(ldev[,...])[ldev[,...]] [,...]] [;NAME=backupname]


NOTE  The DIRECTORY, LISTDIR, VOL, VOLCLASS, VOLSET, FCRANGE, MOSET, and
      NAME parameters cannot be used when restoring a tape created with
      the TRANSPORT parameter (compatibility mode) or from an MPE V/E
      tape.


Parameters 

The TurboSTORE/XL II specific parameters are:

       RESTORESET
       MOSET (optical media only)
       NAME (optical media only)

These parameters are described below.  For information on all other
RESTORE parameters, refer to the MPE XL Commands Reference Manual 
(32650-90003).[REV END]

RESTORESET.   

Use the RESTORESET parameter to specify sequential and parallel backup
devices in the same manner as you did with STORESET.
[REV BEG]

MOSET.   

Use the MOSET parameter to specify sequential and parallel DASS restore
devices.  The MOSET parameter may not be used if a restorefile is
specified.


NOTE  The MOSET parameter is available only if you are using
      TurboSTORE/XL II with Optical Support (product numbers 36397A and
      36398A).


NAME.   

Use the NAME parameter to specify the particular name for the backup you
wish to restore.  The NAME parameter is required to restore from a DASS
device.


NOTE  The NAME parameter is available only if you are using TurboSTORE/XL
      II with Optical Support (product numbers 36397A and 36398A).

[REV END]

MPE/iX 5.0 Documentation