HP 3000 Manuals HP 3000 Manuals
Summary of Commands to Change Paths
DBChange Plus provides specific commands to change paths in a database.
Table 6-1 alphabetically lists the commands that change paths and
summarizes their functions:
Table 6-1. Summary of Commands to Change Paths
----------------------------------------------------------------------------------------------
| | | |
| Command | Keyword | Description |
| | | |
----------------------------------------------------------------------------------------------
| | | |
| ADD | PATH | Adds a path from a detail data set to a master data |
| | | set. |
| | | |
----------------------------------------------------------------------------------------------
| | | |
| CHANGE | PRIMARYPATH | Redefines the primary path of a detail data set |
| | | with at least two paths. |
| | | |
----------------------------------------------------------------------------------------------
| | | |
| DELETE | PATH | Deletes a path from a detail data set. |
| | | |
----------------------------------------------------------------------------------------------
NOTE
* Before invoking any of the following commands, you must log
on to the system as the database creator, run the DBCPLUS
program, and specify the database for which you want to
change paths. Refer to chapter 1, "Introduction to DBChange
Plus."
* The commands are not actually applied until the DBAPLUS
program is used. Refer to chapter 9, "Applying Changes to
the Database Structure."
* Paths can only be added, redefined, or deleted from a detail
data set. For example, paths to a manual master data set
must be added through the related detail data set.