HP 3000 Manuals HP 3000 Manuals
STOREINFO
This command lists the physical name of all the files backed up on a
specified tape.
Scope
SQLUtil Only
SQLUtil Syntax
>> STOREINFO From File Name: StoreFileName
Parameters
StoreFileName is the name of the tape volume.
Description
* The STOREINFO command lists the names of the DBEFiles stored on
the specified device.
* The STOREINFO command should be used from the same group and
account from which the STORE or STOREONLINE command was issued.
This is usually the group and account containing the DBECon file
and the SYSTEM DBEFileSet.
* If the backup was created using a full STORE or STOREONLINE, the
DBECon file will be shown as one of the listed files. If the
backup was created using a STORE PARTIAL or STOREONLINE PARTIAL,
the DBECon file is not stored and will not be shown in the list of
stored files.
* If the DBEFiles have been moved to a group and account different
from the one containing the DBECon file and the SYSTEM DBEFileSet,
the fully qualified file name will be shown by STOREINFO. When you
later restore the files, you must be in the group and account from
which the files were stored (usually the group and account
containing the DBECon file and SYSTEM DBEFileSet) and the file
name used for the restore process must be exactly as shown by the
STOREINFO command.
Authorization
Anyone can list the physical names of files on the archive.
Example
>> STOREINFO
From File Name: TAPE
DBEfile Name: PartsDBE
DBEfile Name: PartsF0
DBEfile Name: PurchDF1
DBEfile Name: PurchFX1
DBEfile Name: driveB/WarehDF1
DBEfile Name: driveC/WarehXF1
DBEfile Name: OrderDF1
DBEfile Name: FileData
DBEfile Name: RecDF1