HP 3000 Manuals

ALLBASE/NET User's Guide

Chapter 2  Setting Up ALLBASE/NET 

This chapter provides you with procedures for setting up ALLBASE/NET on
both the client and server.  It explains how to:

       [REV BEG]

   *   Use NETUtil to migrate profiles before HP-UX 10.0 is installed on
       a server system.[REV END]

   *   Invoke and use NETUtil.

   *   Set up ALLBASE/NET on the client.

   *   Set up ALLBASE/NET on the server.[REV BEG]

Before you begin setting up ALLBASE/NET, make sure your networking
software is up and running.  To do this, type NSCONTROL STATUS at the
system prompt.  For more information on this and other listener commands,
refer to the section "Setting Up ALLBASE/NET on the Server" in this
chapter.[REV END]

MPE/iX 5.0 Documentation