HP 3000 Manuals

MPE/iX Commands Reference Manual Volume I

CHGROUP 

Switches you from the current group to another group within the logon
account to which you are allowed access.  (Native Mode)

Syntax 

CHGROUP [[groupname][/grouppass]]


NOTE  This command follows the optional MPE/iX command line syntax.
      Refer to "Optional Format for MPE/iX Commands" at the beginning of
      this chapter.


Parameters 

groupname             The name of the group to which the user is
                      switched.  If the parameter is omitted, the user is
                      switched to the home group.

grouppass             The password of the group you are switching to, if
                      it is assigned a password.  In a session, if the
                      target group has a password and you fail to supply
                      one on the command line, MPE/iX will prompt you to
                      enter one.  You have three tries to enter the
                      correct password before the command fails.

                      In a batch job, if the target group has a password
                      and you fail to supply one, MPE/iX issues an error
                      message "INCORRECT PASSWORD (CIERR 1441)" and the
                      job fails.

                      In either case, when you switch to your home group,
                      you may omit the password.

Operation Notes 

This command changes the user's current group to groupname.  The entire
command interpreter environment is preserved (temporary files, file
equations, cataloged UDCs, and variables).  The user must know the
password, if any, for groupname.  In a session, if a password is
associated with groupname, and the user fails to supply a grouppass, the
system prompts the user to enter one.  In a job, if a password is
associated with groupname, and the user fails to supply a grouppass, the
error message INCORRECT PASSWORD (CIERR 1441) is issued and the job
fails.

The CHGROUP and CHDIR commands both change their process' CWD. However,
CHDIR does not post any accounting information, and CHGROUP affects the
CWD of every process in the job/session structure.  Connect and CPU times
are still accounted to the user's logon account and logon group.

Use 

This command is available in a session or a job, but not in BREAK or from
a program.  Pressing Break has no effect on this command.

Examples 

To switch the user from the current group to the group called GORODA,
enter:

     CHGROUP GORODA 

To switch the user from the current group to the group called GORODA,
with the assigned password MUSASHI, enter:

     CHGROUP GORODA/MUSASHI 

To switch the user from the current group to the user's home group,
enter:

     CHGROUP 

Related Information 

Commands      CHDIR, HELLO

Manuals       None

MPE/iX 5.5 Documentation