HP 3000 Manuals HP 3000 Manuals
Showing Current LOG Values
The SHOW command displays the LOG values as currently set.
SHOW has the following parameters:
SHOW [COMMAND = SLOG ]
ULOG ]
ALL ]
[DEST = OFFLINE ]
SLOG lists the state of the system logging events.
ULOG lists the number of user logging processes and users per logging
process currently configured.
ALL lists all the information associated with the LOG configurator.
OFFLINE redirects the output of the SHOW command to the SYSGEN listing
file, SYSGLIST. Using OFFLINE does not immediately generate a printout.
The information is sent to SYSGLIST until you either enter the OCLOSE
command or exit the configurator. Exiting the configurator or using
OCLOSE closes SYSGLIST and prints the file.
Using SHOW without using any parameters, is the same as specifying SHOW
ALL. In addition, the value entered for the ULOG parameter includes the
minimum, maximum, current, and default values.
To show the current user logging process, enter SHOW ULOG:
_______________________________________________________________________
| |
| |
| log>SHOW ULOG |
| configurable item max min current |
| ----------------- ------- ------- ------- |
| # of user logging processes 128 2 64 |
| # users per logging process 1024 1 128 |
| |
_______________________________________________________________________
Example 6-4. Showing User Logging Processes
To view all currently configured values, enter SHOW ALL:
_______________________________________________________________________
| |
| |
| log>SHOW ALL |
| configurable item max min current |
| ----------------- ------- ------- ------- |
| # of user logging processes 128 2 64 |
| # users per logging process 1024 1 128 |
| |
| system log events event # status |
| ----------------- ------- ------ |
| System Logging 100 ON |
| System Up 101 ON |
| Job Initiation 102 OFF |
| Job Termination 103 OFF |
| Process Termination 104 OFF |
| NM File Close 105 OFF |
| System Shutdown 106 ON |
| Power Failure 107 ON |
| I/O Error 111 ON |
| Physical Mount/Dismount 112 OFF |
| Logical Mount/Dismount 113 OFF |
| Tape Label 114 OFF |
| Console Log 115 ON |
| Program File Event 116 ON |
| Native Mode Spooling 120 ON |
| Chdir 127 OFF |
| Process Adoption 128 OFF |
| File Owner Change 129 OFF |
| Architected Interface 130 OFF |
| Additional Processor Launch 131 ON |
| Password Change 134 OFF |
| System Logging Configuration 135 OFF |
| Restore 136 ON |
| Printer Access Failure 137 OFF |
| ACD Change 138 ON |
| Stream Initiation 139 ON |
| User Logging 140 ON |
| Process Creation 141 OFF |
| Security Configuration Change 142 OFF |
| Chgroup 143 ON |
| File Open 144 OFF |
| CI Command Logging 145 OFF |
| Maintenance Request 146 OFF |
| UPS Monitor Event Logging 148 OFF |
| Diagnostic Information 150 ON |
| High Priority Machine Check 151 ON |
| Low Priority Machine Check 152 ON |
| Directory Open/Close Logging 155 OFF |
| CM File Close 160 OFF |
| |
_______________________________________________________________________
Example 6-5. Showing All Configured Values