HP 3000 Manuals HP 3000 Manuals
Class Errors (Cont'd.)
Class Error 5: Bus Protocol Failure
Bus protocol messages takes the form:
5sxx
where:
s = slot number
xx = detailed error number.
-------------------------------------------------------------
00 MESSAGE No message. System halts. (E)
CAUSE Undefined error occurs at the start of this test.
ACTION Contact your Hewlett-Packard Support
Representative.
-------------------------------------------------------------
Class Error 7: Memory Failure
Class Error 7
memory error messages takes the form:
7sxx
where:
s = slot number
xx = detailed error number.
NOTE The memory test takes about 1.5 seconds per MB of memory.
-------------------------------------------------------------
00 MESSAGE No message. System halts. (E)
CAUSE Undefined error occurs at the start of the test of
this board.
ACTION Contact your Hewlett-Packard Support
Representative.
-------------------------------------------------------------
01 MESSAGE No message. System halts. (E)
CAUSE Either stuck bit occurs in I/O status register or
cannot find four contiguous words within the first
256 KB without a single bit error.
ACTION Contact your Hewlett-Packard Support
Representative.
-------------------------------------------------------------
02 MESSAGE No message. System halts. (E)
CAUSE Verification of the memory with its address fails.
Second possible cause of the error is the cache
unit. Third possible cause of the error is the
TLB.
ACTION Contact your Hewlett-Packard Support
Representative.
-------------------------------------------------------------
03 MESSAGE No message. System halts. (E)
CAUSE Pattern testing memory fails. Second possible
cause of the error is the cache unit. Third
possible cause of the error is the TLB.
ACTION Contact your Hewlett-Packard Support
Representative.
-------------------------------------------------------------
04 MESSAGE No message. System halts. (E)
CAUSE Multiple bit error flag is set by single bit error.
Second possible cause of the error is the cache
unit.
ACTION Contact your Hewlett-Packard Support
Representative.
-------------------------------------------------------------
05 MESSAGE No message. System halts. (E)
CAUSE Multiple bit error flag is not set by multiple bit
error. Second possible cause of the error is the
cache unit.
ACTION Contact your Hewlett-Packard Support
Representative.
-------------------------------------------------------------
06 MESSAGE No message. System halts. (E)
CAUSE Memory controller cannot calculate the address of
the faulty memory. Second possible cause of the
error is the cache unit.
ACTION Contact your Hewlett-Packard Support
Representative.
-------------------------------------------------------------
07 MESSAGE No message. System halts. (E)
CAUSE Single bit error is detected. Second possible
cause of the error is the cache unit.
ACTION Contact your Hewlett-Packard Support
Representative.
-------------------------------------------------------------
0A MESSAGE No message. System halts. (E)
CAUSE Parity checking/generator is not working. Second
possible cause of the error is the cache unit.
ACTION Contact your Hewlett-Packard Support
Representative.
-------------------------------------------------------------
0B MESSAGE No message. System halts. (E)
CAUSE Verification of read/write protocol fails. Second
possible cause of the error is the cache unit.
ACTION Contact your Hewlett-Packard Support
Representative.
-------------------------------------------------------------
0C MESSAGE No message. System halts. (E)
CAUSE Verification of read and Clear protocol fails.
Second possible cause of the error is the cache
unit.
ACTION Contact your Hewlett-Packard Support
Representative.
-------------------------------------------------------------
10 MESSAGE No message. System halts. (E)
CAUSE Undefined type of memory controller is found.
ACTION Contact your Hewlett-Packard Support
Representative.
-------------------------------------------------------------
11 MESSAGE No message. System halts. (E)
CAUSE Error occurs as "hole" in memory is detected.
ACTION Install 32 MB memory controller. Contact your
Hewlett-Packard Support Representative.
-------------------------------------------------------------
12 MESSAGE No message. System halts. (E)
CAUSE Last memory controller does not have a memory array
installed.
ACTION Contact your Hewlett-Packard Support
Representative. Install memory array.
-------------------------------------------------------------
13 MESSAGE No message. System halts. (E)
CAUSE Last 8 MB (3 MB MC and 5 MB MA) memory controller
does not have a memory array installed.
ACTION Contact your Hewlett-Packard Support
Representative. Install memory array.
-------------------------------------------------------------
2F MESSAGE No message. System halts. (E)
CAUSE No memory board is found during initialization.
Second possible cause of the error is the cache
unit.
ACTION Contact your Hewlett-Packard Support
Representative.
-------------------------------------------------------------