HP 3000 Manuals HP 3000 Manuals
Stopping Spooling
Use the NMS command SPOOLER with the parameter STOP or the command
STOPSPOOL. By default, these commands also close the spooling queues for
the device(s).
Both commands stop spooling for all devices in a specified device class.
To stop spooling for device class LP, which contains three devices 6, 11,
and 19, enter:
SPOOLER LP;STOP
The spooling process is stopped for each of the devices 6, 11, and 19.
By default, the spooling queues for the three devices are closed.