HP 3000 Manuals HP 3000 Manuals
HPLOADNMPROC
CM callable only.
Returns the plabel of an NM procedure.
Syntax
_____________________________________________________
| |
| U32 CA I16V CA |
| plabel:=HPLOADNMPROC(procname,proclen,libname,|
| I16V |
| liblen) |
_____________________________________________________
Functional Return
plabel 32-bit unsigned integer (assigned functional
return)
Plabel of the target NM procedure.
Parameters
procname character array by reference (required)
Passes the target procedure name. The target
procedure must be contained in an executable
library (XL). If the value of procname is invalid,
blank, or does not contain the NM procedure,
NL.PUB.SYS is searched.
proclen 16-bit signed integer by value (required)
Passes the byte length of the procedure name.
libname character array by reference (required)
Passes the name of the NM library to be searched
for the target. If the value of libname is
invalid, blank, or does not contain the NM
procedure, NL.PUB.SYS is searched.
liblen 16-bit signed integer by value (required)
Passes the byte length of the library name.
Operational Notes
Do not use HPLOADNMPROC to invoke a native mode (NM) system-supplied
intrinsic. The result of the call may be unpredictable.
Used to obtain the NM plabel of the target procedure. Then the plabel is
used by the HPSWTONMPLABEL intrinsic for its proc parameter.
The strings you supply as values of the procname and libname parameters
must exactly match the names of the target NM routine and its NM library,
respectively.
Related Information
Intrinsics HPSWITCHTOCMPROCEDURE
Commands None
Manuals Switch Programming Guide (32650-90014)