HP 3000 Manuals HP 3000 Manuals
FTNGO
Compiles, prepares, and executes a compatibility mode HP FORTRAN 77/V
program. HP FORTRAN 77/V is not part of the 900 Series HP 3000 Computer
System Fundamental Operating Software and must be purchased separately.
The native mode equivalent of this command is the FTNXLGO command.
Syntax
FTNGO [textfile][,listfile][;INFO=quotedstring]
Parameters
textfile Actual file designator of the input file from which
the source program is read. This can be any ASCII
input file. Formal file designator is FTNTEXT.
Default is $STDLIST.
listfile Actual file designator of the file to which the
program listing is written. This can be any ASCII
output file. Formal file designator is FTNLIST.
Default is $STDLIST.
NOTE The formal file designators used in this command (FTNTEXT and
FTNLIST) cannot be backreferenced as actual file designators in the
command parameter list. For further information, refer to the
"Implicit FILE Commands for Subsystems" discussion of the FILE
command.
quotedstring A sequence of characters between two single
quotation marks (apostrophes) or between two double
quotation marks. You may use the delimiter as part
of the string so long as the delimiter appears
twice. Any occurrence of two single or two double
quotation marks in a row, is considered part of the
string, and, therefore, not the terminating
delimiter.
INFO=quotedstring is used in the HP FORTRAN 77/V
programming language to pass initial compiler
options to a program.
Operation Notes
The FTNGO command compiles, prepares, and executes an HP FORTRAN 77/V
program. If textfile is omitted, MPE/iX expects input from your standard
input device. If you do not specify listfile, MPE/iX sends the program
listing to the formal file designator FTNLIST (default is $STDLIST).
The USL file created during the compilation is the system-defined
temporary file $OLDPASS, which is passed directly to the MPE segmenter.
It cannot be accessed because the segmenter also uses $OLDPASS to store
the prepared program segments, overwriting any existing temporary file of
the same name.
Use
This command may be issued from a session, job, or program. It may not
be used in BREAK. Pressing Break suspends the execution of this command.
Entering the RESUME command continues the execution.
Examples
To compile, prepare, and execute an HP FORTRAN 77/V program entered from
your standard input device, with the program listing sent to your
standard list device, enter:
FTNGO
To compile, prepare, and execute an HP FORTRAN 77/V program from the disk
file FORTSRC and send the program listing to the file LISTFILE, enter:
FTNGO FORTSRC,LISTFILE
Related Information
Commands FTN, FTNPREP, RUN, XEQ, PREP, SEGMENTER
Manuals HP FORTRAN 77/iX Reference (31501-90010)
MPE Segmenter Reference Manual (32650-60026)