HP 3000 Manuals HP 3000 Manuals
Running the CI as a Program
The MPE/iX Command Interpreter (CI) is a Native Mode Program. You can
run it the way you would any other program, either by explicitly using
the RUN command (the first example below), or by using the the implied
RUN (the second example):
RUN CI.PUB.SYS
CI
In the first case, the RUN command controls execution of the CI. For more
information, refer to the RUN command in this chapter.
The second case, referred to as implied run, is limited to recognizing
the INFO= and PARM= parameters. If you enter both INFO= and PARM=, PARM=
goes into effect after the INFO= string is passed.
Table 2-1. Parm= values for the CI
--------------------------------------------------------------------------------------------
| | |
| Parm | Action |
| | |
--------------------------------------------------------------------------------------------
| | |
| 0 | UDC's are cataloged, the CI banner is displayed, and the WELCOME message |
| | is displayed. This is the default. |
| | |
| 1 | Same as 0, however the CI terminates after processing the info string; it |
| | terminates after the first command is executed if no info string is |
| | specified. |
| | |
| 2 | UDC's are cataloged, the CI banner is suppressed, and the WELCOME message |
| | is suppressed. |
| | |
| 3 | Same as 2, however the CI terminates after processing the info string; it |
| | terminates after the first command is executed if no info string is |
| | specified. |
| | |
| 4 | Logon UDC's are executed, UDC's are available, the CI banner is |
| | displayed, and the WELCOME message is displayed. |
| | |
| 5 | Same as 4, however the CI terminates after processing the info string; it |
| | terminates after the first command is executed if no info string is |
| | specified. |
| | |
| -1 | UDC's are not cataloged, the CI banner is suppressed, and the WELCOME |
| | message is suppressed. This requires SM capability. |
| | |
| -2 | Same as -1, however the CI terminates after processing the info string; |
| | it terminates after the first command is executed if no info string is |
| | specified. This requires SM capability. |
| | |
--------------------------------------------------------------------------------------------