HP 3000 Manuals HP 3000 Manuals
BBASICGO
Compiles, prepares, and executes an HP Business BASIC/V program in
compatibility mode. HP Business BASIC/V is not part of the 900 Series HP
3000 Computer System Fundamental Operating Software and must be purchased
separately.
Syntax
BBASICGO infile[,listfile]
Parameters
infile Actual file designator of the BSAVE file containing
the HP Business BASIC/V program to be compiled.
Formal file designator is BBCIN.
listfile Actual file designator of the file to which the
program listing is written. This can be any ASCII
output file. Formal file designator is BBCLIST.
Default is $STDLIST.
NOTE The formal file designators used in this command (BBCIN and
BBCLIST) cannot be backreferenced as actual file designators in the
command parameter list. Refer to the "Implicit FILE Commands for
Subsystems" discussion of the FILE command.
Operation Notes
This command compiles, prepares, and executes a program from a BSAVE file
created by the HP Business BASIC/V interpreter. This enables the program
to run faster than it would if it were executed by the interpreter.
You may create a BSAVE program file within the HP Business BASIC/V
interpreter after it is saved by using the HP Business BASIC/V
interpreter >SAVE filename command. The program then can be compiled,
prepared, and executed with the BBASICGO command.
Use
This command may be issued from a session, job, or program. It may not
be used in BREAK. Pressing Break suspends the execution of this command.
Entering the RESUME command continues the execution.
Example
To compile, prepare, and execute the HP Business BASIC/V program MYPROG
and send the listing to the disk file LISTFL, enter:
BBASICGO MYPROG,LISTFL
Related Information
Commands BBASIC, BBASICOMP, BBASICPREP
Manuals HP Business BASIC/XL Reference Manual (32715-60001)
MPE Segmenter Reference Manual (32650-60026)