HP 3000 Manuals

MPE/iX Commands Reference Manual Volume I

RPGXLGO 

Compiles, links, and executes an RPG/XL program.  RPG/XL is not part of
the 900 Series HP 3000 Computer System Fundamental Operating Software and
must be purchased separately.  This command is recognized only if RPG/XL
is installed on your system.  (Native Mode)

Syntax 

RPGXLGO [textfile][,[listfile]]


NOTE  This command follows the optional MPE/iX command line syntax.
      Refer to "Optional Format for MPE/iX Commands" at the beginning of
      this chapter.


Parameters 

textfile              Actual file designator of the input file from which
                      the source program is read.  This can be any ASCII
                      input file.  Formal file designator is RPGTEXT.
                      Default is $STDLIST.

listfile              Actual file designator of the file to which the
                      program listing is written.  This can be any ASCII
                      output file.  Formal file designator is RPGLIST.
                      Default is $STDLIST.


NOTE  The formal file designators used in this command (RPGTEXT and
      RPGLIST) cannot be backreferenced as actual file designators in the
      command parameter list.  For further information, refer to the
      "Implicit FILE Commands for Subsystems" discussion of the FILE
      command.


Operation Notes 

The RPGXLGO command compiles, links, and executes an RPG/XL program.  If
textfile is omitted, RPG/XL expects input from your standard input
device.  If you do not specify listfile, RPG/XL sends the program listing
to the formal file designator RPGLIST (default is $STDLIST).

The object file created during compilation is a system-defined temporary
file, $NEWPASS, which is passed directly to the Link Editor as $OLDPASS.
The Link Editor purges the object file and writes the linked program to
$OLDPASS, which is then executed and may be executed repeatedly.


NOTE  This command is implemented as a command file.  If you set the
      HPPATH variable to null (SETVAR HPPATH ""), the command file is not
      executed, and the command fails.


Use 

This command may be issued from a session, job, or program.  It may not
be used in BREAK. Pressing Break suspends the execution of this command.
Entering the RESUME command continues the execution.

Example 

To compile, link, and execute an RPG/XL program entered from your
standard input device, with the program listing sent to your standard
list device, enter:

     RPGXLGO 

To compile, link, and execute an RPG/XL program from the disk file RPGSRC
and send the program listing to the file LISTFILE, enter:

     RPGXLGO RPGSRC,LISTFILE 

Related Information 

Commands      RPGXL, RPGXLLK

Manuals       HP RPG/XL Programmer's Guide (30318-60001)

              HP RPG/XL Reference Manual (30318-60002)

              HP RPG Utilities Reference Manual (30318-60003)

MPE/iX 5.0 Documentation