HP 3000 Manuals HP 3000 Manuals
RESUMELOG
Resumes system logging following suspension caused by an error. (Native
Mode)
Syntax
RESUMELOG
Parameters
None.
Operation Notes
When the operator resumes logging with the RESUMELOG command, a special
log record is displayed that denotes the number of log events and
corresponding records that were not recorded while logging was suspended,
the total number of unrecorded job initiation records, and the total
number of unrecorded job/session termination records.
Use
This command may be issued from a session, job, program, or in BREAK. It
may be executed only from the console, or by a user with system
supervisor (OP) capability.
Examples
Assume the system is online and running with logging enabled. If a
recoverable error occurs, the following error message is sent to the
system console:
ST/10:43/LOG FILE NUMBER 104 ERROR #46.
LOGGING SUSPENDED.
After the error is corrected, enter RESUMELOG. A confirmation message
then appears at the system console, as follows:
ST/10:45/LOG FILE NUMBER 104. LOGGING RESUMED.
ST/10:45/LOG FILE NUMBER 104 ON.
Related Information
Commands ALTLOG, CHANGELOG, GETLOG, LISTLOG, LOG, OPENLOG, RELLOG,
SHOWLOGSTATUS, SWITCHLOG,
Manuals System Startup, Configuration, and Shutdown Reference
Manual (32650-90042)