HP 3000 Manuals HP 3000 Manuals
RECALL/=RECALL
Displays all pending console REPLY messages.
Syntax
RECALL
=RECALL
Parameters
None.
Operation Notes
A user, the system operator, a job or a program issues the RECALL command
to determine if any pending resource requests are currently awaiting a
response. Pending resource requests are responded to by using the REPLY
command.
Use
This command may be issued from a session, job, program, or in BREAK.
Pressing Break has no effect on this command. It may be issued only from
the console.
Any user may execute the RECALL command. However, the CTRL A =RECALL
command may only be executed at the physical console, and cannot be
executed from a job or a program.
Examples
To display all pending system console messages, which require a response,
enter:
RECALL
THE FOLLOWING REPLIES ARE PENDING:
10:05/#J19/15/LDEV # FOR "L00576" ON TAPE1600 (NUM)?
If any replies are pending, the request(s) are displayed on the console
as shown above. If no replies are pending, the following message appears
on the console:
RECALL
NO REPLIES PENDING (CIWARN 3020)
Use the =RECALL command if the RECALL command is ineffective, or when a
job or subsystem is being executed from the console.
CTRL A
=RECALL
NO REQUESTS PENDING (SYS 15)
Related Information
Commands REPLY
Manuals STORE and TurboSTORE/iX Manual (30319-90001)
Performing System Operation Tasks (32650-90137)