HP 3000 Manuals HP 3000 Manuals
LOG
Starts, restarts, or stops user logging.
Syntax
{,RESTART}
LOG logid {,START }
{,STOP }
Parameters
logid Logging identifier previously established with a
user GETLOG command.
START Initiates a logging process.
RESTART Restarts a logging process.
STOP Terminates a logging process.
Operation Notes
This command allows you to start, restart, or stop user logging. For
further discussion of user logging, refer to the User Logging
Programmer's Guide (32650-60012).
To change log files without the delay normally caused by executing a LOG
command, use the CHANGELOG command to enable interactive log file
changing. Use the AUTO parameter of the ALTLOG and GETLOG commands to
enable automatic log file changing.
Use
This command may be issued from a session, job, program, or in BREAK.
Pressing Break has no effect on this command.
This command can be executed only by users to whom it has been allowed
(see ALLOW command) or to users logged onto the console (or to a terminal
that has taken the console via the CONSOLE command). System Supervisor
(OP) capability is also required.
Example
To start the logging process identified by logid LOGPROCX, enter:
LOG LOGPROCX,START
Related Information
Commands ALTLOG, CHANGELOG, GETLOG, SHOWLOGSTATUS
Manuals User Logging Programmer's Guide (32650-60012)