HP 3000 Manuals HP 3000 Manuals
LISTLOG
Lists currently active logging identifiers on the system and whether
automatic log file changing has been enabled.
Syntax
LISTLOG [logid[;PASS]]
Parameters
logid The specific logging identifier to be verified.
Default is to list all currently active logging
identifiers on the system.
PASS Causes the password associated with the logging
identifier to be displayed. This option can be
used only by the creator of the logging identifier.
Operation Notes
This command lists the logging identifier specified with its associated
creator and log file. The column labeled CHANGE indicates whether the
CHANGELOG command is permitted; that is, whether the name of the first
logging file ends in 001 and thus follows the naming convention required
by the CHANGELOG command. The column labeled AUTO indicates whether an
automatic CHANGELOG is permitted; that is, whether the AUTO parameter has
been specified with a GETLOG or ALTLOG command.
If the logid parameter is not entered, all logging identifiers on the
system are displayed with their creators and log files. The PASS
parameter, which can be used only by the creator of the logging
identifier specified, causes the password associated with the logging
identifier to be listed.
Use
This command may be issued from a session, job, program, or in BREAK.
Pressing Break has no effect on this command. System supervisor (OP) or
user logging (LG) capability is required to use this command.
Example
To list all logging identifiers on the system, enter:
LISTLOG
LOGID CREATOR CHANGE AUTO CURRENT LOGFILE
TESTLOG LALITHA.MPEM YES YES LAL001.PEJ
TEST1 MARK.MPEM YES NO M001.KSAM3
TEST2 PAT.MPEM NO NO TEST.ALVAR
Related Information
Commands ALTLOG, CHANGELOG, GETLOG, LOG, OPENLOG, SHOWLOGSTATUS,
RELLOG
Manuals User Logging Programmer's Guide (32650-60012)